FIELD CONTROLS UV-18X User Manual
Page 3
2. Determine the type of duct you have.
(For flex duct applications, refer to Figure 21 on page 8)
I
F YOU HAVE METAL DUCT
:
a. Apply supplied wet and stick mounting template to air duct
in either a vertical or horizontal position as shown in Figure
2.
2.
b. Drill 1/8” diameter mounting holes at positions indicated on
template.
c. Cut out rectangular hole on template using a pair of tin
snips or jigsaw. (See Figure 2) Remove template.
I
F YOU HAVE DUCT BOARD
:
a. Mount the supplied metal mounting plate onto the duct with
duct tape in either a vertical or horizontal position as shown
in Figure 2. (See Figure 3)
in Figure 2. (See Figure 3)
b. Bend tabs outward as shown in figure 4.
c. Using a knife or blade, cut out a rectangle opening in the duct using the mounting plate as a template. (See
Figure 5)
d. Remove the cut piece of duct. (See Figure 7)
e. Bend both tabs down and through duct at first bend point. (See Figures 8 &9)
f. Bend both tabs at the second bend point up or down to pinch the duct material and grip the duct material.
(See Figures 10 & 11
g. Using a screwdriver or pointed object, locate mounting holes by poking holes through the duct tape. (See
Figure 12)
Figure 2
Figure 3
Figure 4
Figure 7
Figure 8
Figure 9
Figure 10
Figure 11
Figure 12
Figure 5
WARNING: Never expose eyes or skin to UVC light from any source. Looking directly at the UVC light may cause permanent eye damage or
blindness. Never operate the UV-Aire™ Air Purifying System out of the plenum. Avoid touching the glass portion of the lamp with your
hands.
blindness. Never operate the UV-Aire™ Air Purifying System out of the plenum. Avoid touching the glass portion of the lamp with your
hands.