AllerAir DX Leaflet

AllerAir Industries Inc.

Toll free: 1-888-852-8247 / Fax: 1-877-688-2193 www.allerair.com

FILTER

ASSEMBLY

D, DS, DX &

6000 MODELS

Step 1

Make sure the unit is set to "Off,"
and unplug it. Lay the unit upside
down, so that the wheels face up.

Step 2

Using a #2 Philips screwdriver,
remove the four screws that hold
the base onto the unit.

Step 7

Replace the base, making sure the
arrow on the gold sticker lines up
with unit's rear seam.

Step 8

Replace the four screws.

Step 9

Turn the unit back onto its wheels.
It is now ready for use.

Step 3

Grasp the wheels. Remove the base
by pulling gently on the wheels.

Step 5

Gently insert the carbon filter
(either a Model D, DS or DX Carbon)
into the unit, either end up.
For 6000 Carbon/Hepa Models
Insert carbon canister, then Hepa in
center

Step 4

Reach inside the unit, and remove
only 1 of the 2 felt pads.

Step 6

Put back the felt pad removed in
STEP 4.

A Message for the Client

NEW

CARBON

The model you have selected is shipped in 2 separate boxes to protect certain

components. The filter comes in one box, and the outer shell of the unit,

containing the motor and the fan, comes in another. Filters must be installed

before turning the unit on in order for it to work. AllerAir technicians

recommend removing the base, installing the filter, and replacing the base

according to the following steps:

HEPA