Emerson Process Management 3422 User Manual
Meter setup and configuration worksheet
Reference, Installation, and Operations Manual
June 2013
3-9000-743 Rev S
329
Meter to Flow Computer Communication Worksheet
Analog Output
AO1
(Option Board or
Series 100 Option Board)
AO1
(Option Board or
Series 100 Option Board)
User Selection (Circle one)
Results (Enter here)
Electrical Configuration
•
Sink
•
Source (i.e., powered by the meter) If the analog output is configured for
source mode, then it must be at the bottom of the loop (stack).
source mode, then it must be at the bottom of the loop (stack).
Direction
•
Forward
•
Reverse
•
Absolute
Full Scale Flow Rate Refer to note in Modbus volume and flow rate units section of this table.
Analog Output
AO2
(Series 100 Option Board)
AO2
(Series 100 Option Board)
User Selection (Circle one)
Results (Enter here)
Electrical Configuration
•
Sink
•
Source (i.e., powered by the meter) If the analog output is configured for
source mode, then it must be at the bottom of the loop (stack).
source mode, then it must be at the bottom of the loop (stack).
Direction
•
Forward
•
Reverse
•
Absolute
Analog Input
AI1 (Temperature)
AI1 (Temperature)
Live or specified temperature can be used for bulk volume correction.
Electrical Configuration
•
Sink
•
Source (i.e., powered by the meter)
If the analog input is configured for source mode, then it must be at the
bottom of the loop (stack).
bottom of the loop (stack).
Minimum Input
(temperature
corresponding to 4mA input)
•
______
o
C
(if metric units system selected)
•
______
o
F
(if US Customary units
system selected)
system selected)
Maximum Input
(temperature
corresponding to 20mA input)
•
______
o
C
•
______
o
F
Low Alarm
•
______
o
C
•
______
o
F
High Alarm
•
______
o
C
•
______
o
F
Note: If the temperature is at or outside these limits, an alarm is generated
Note: Temperature is required for optional meter internal diameter Temperature expansion correction. If a temperature transmitter is connected to
the meter, select Live for this option. If a temperature transmitter is not connected to the meter but temperature expansion correction is required,
select Fixed. You will enter in a fixed temperature on a later page. If the correction is not required, select Not used.
the meter, select Live for this option. If a temperature transmitter is not connected to the meter but temperature expansion correction is required,
select Fixed. You will enter in a fixed temperature on a later page. If the correction is not required, select Not used.
Table E-2 Meter to Flow Computer Communication Worksheet (Sheet 8 of 9)
Description