Vermont Casting DEFD26 User Manual
9
10005581
Vermont Castings, Majestic Products DEF/ DEFD26
Operating Instructions
1. Main ON/OFF Switch
The ON/OFF switch supplies power to all functions of
the fireplace. This is an illuminated switch which
normally lights up when in the ON or OFF position.
the fireplace. This is an illuminated switch which
normally lights up when in the ON or OFF position.
NOTE: The control compartment is located behind the upper louvre panel. To access controls, flip the upper
louvre panel down.
2. Heater Control
The Heater Control acts to turn the heater ON and
OFF as well as setting the comfort level in the room.
Turning the knob clockwise from the OFF position will
place the heater into operation. The further the knob is
rotated clockwise, the higher the setpoint temperature.
Turning the knob counterclockwise will lower the
setpoint temperature. Turning it all the way
counterclockwise will turn the heater function OFF.
OFF as well as setting the comfort level in the room.
Turning the knob clockwise from the OFF position will
place the heater into operation. The further the knob is
rotated clockwise, the higher the setpoint temperature.
Turning the knob counterclockwise will lower the
setpoint temperature. Turning it all the way
counterclockwise will turn the heater function OFF.
WARNING: During any service of this
appliance, the power to the unit must be
turned
appliance, the power to the unit must be
turned
OFF. It is not acceptable to use the
ON/OFF switch to meet this requirement.
Fig. 3 Control locations behind upper louvre panel.
10005754
Turn the flame speed control knob to increase or
decrease the flame speed as desired.
decrease the flame speed as desired.
3. Flame Speed Control
4. Re-learn
This model fireplace with integral remote control has a
preprogrammed, matched-pair Receiver/Transmitter
already set with randomly-selected house codes. It is
highly unlikely that the fireplace code will ever need to
be re-learned. If the fireplace needs to re-learn
Receiver/Transmitter house codes, perform the
following steps:
preprogrammed, matched-pair Receiver/Transmitter
already set with randomly-selected house codes. It is
highly unlikely that the fireplace code will ever need to
be re-learned. If the fireplace needs to re-learn
Receiver/Transmitter house codes, perform the
following steps:
1. Be sure there is power to the fireplace.
2. Be sure there is a good battery in the Transmitter
(hand-held remote).
3. Open the battery compartment of the remote.
4. Press and release the small button located in the
top left corner. This will randomly select a new
house code in the remote Transmitter.
house code in the remote Transmitter.
5. Close the remote Transmitter battery
compartment.
6. Press either the ON or OFF button on the remote
Transmitter, and the Learn button on the fireplace
at the same time. The fireplace is now ready to
accept commands from the remote Transmitter.
at the same time. The fireplace is now ready to
accept commands from the remote Transmitter.
5. ON/OFF
The ON/OFF button on the fireplace (below the Learn
button) is to turn the fireplace ON and OFF when the
battery in remote Transmitter is weak, or to manually
operate the fireplace without the remote Transmitter.
button) is to turn the fireplace ON and OFF when the
battery in remote Transmitter is weak, or to manually
operate the fireplace without the remote Transmitter.
NOTE: The device complies with Part 15 of the
FCC Rules. Operation is subject to the
following two conditions:
following two conditions:
1. This device may not cause harmful
interference, and
2. This device must accept any
interference received, including
interference that may cause
undesired operation.
interference that may cause
undesired operation.
3
1
2
4
5