Monessen Hearth CDV7 User Manual
CDVSC7 & CDV7 Series Gas Fireplace
46
69D3011
GlaSS ReMoVal & RoCK wool plaCeMenT
GlaSS FRaMe ReMoVal
1. Remove upper and lower louvers.
. Release the clamps on the bottom of the fireplace.
. Release the clamps on the bottom of the fireplace.
Figure 61
3. Tilt glass frame out and lift glass frame up until it clears
the hook on top of the frame.
4. Set glass frame aside.
RoCK wool plaCeMenT
1. For best results in flame appearance and opera-
tion, use one (1) 8 gram bag of rock wool for
propane/LP models and up to three (3) bags of
rock wool for natural gas models.
propane/LP models and up to three (3) bags of
rock wool for natural gas models.
. Pull the rock wool apart into dime-sized pieces
or smaller. Cover the entire surface of the burner
with one thin layer of rock wool.
with one thin layer of rock wool.
3. Place the logs on the burner. Refer to the “Log
Placement Section”. Light the unit and after 15
minutes check burner flame and glow. Adjust
embers as necessary to achieve an even and
clean flame.
minutes check burner flame and glow. Adjust
embers as necessary to achieve an even and
clean flame.
FP2297
remove glass
remove glass
Figure 61 -
Removing Glass Frame - CDVR Series Shown
Removing Glass Frame - CDVR Series Shown
Glass Frame
Clamps -
on 33/36 Models,
3 on 4/47 Models
on 33/36 Models,
3 on 4/47 Models
FP97
C
au
TI
on
each clamp has a quick spring force. when
reinstalling clamps, keep fingers clear.
reinstalling clamps, keep fingers clear.
FP2648
BDV rock wool place
BDV rock wool place
Figure 62 - Placement of Rock
Wool on Burner
Wool on Burner
Cover with
Rock Wool
Rock Wool
Burner
FP648
WARNING
!
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
w
a
R
n
In
G
The use of too much rock wool could
cause flame to burn poorly and may cause
sooting.
cause flame to burn poorly and may cause
sooting.