Monessen Hearth CFX24 User Manual

Page of 36
5
CFX Vent Free Fireplace System
20301726
PRODUCT FEATURES & SPECIFICATIONS
OPERATION 
This unvented gas heater requires no outside venting and 
burns cleanly with high heating efficiency.
This zero-clearance unvented gas heater can be installed 
against any wall that is accessible to a gas line.
FP2750
CFX controls
Piezo Ignition
Control Knob
Figure 1 - 
Unvented Gas Heater
(Control Access Door Shown Open)
On/Off Switch 
HI/LO Control Knob
FP2750
GAS PRESSURES
  Control 
Fuel 
Millivolt
  Regulator Pressure 
Nat. 
3.5” w.c. 
  Pilot Regulator 
Nat. 
3.5” w.c. 
  Max. Inlet Pressure 
Nat. 
10.5” w.c. 
  Min. Inlet Pressure 
Nat. 
5.0” w.c. 
  Regulator Pressure 
LP 
10.0” w.c. 
  Max. Inlet Pressure 
LP 
13.0” w.c. 
  Min. Inlet Pressure 
LP 
11.0” w.c. 
   
 
 
 Input BTU/hr
  Model 
Fuel  Control 
Max.    Min.
  CFX24NV 
Nat. 
Millivolt 
22,000    17,000
  CFX24PV 
LP 
Millivolt 
22,000    17,000
  CFX32NV 
Nat. 
Millivolt 
26,000    20,000
  CFX32PV 
LP 
Millivolt 
26,000    20,000
GAS SPECIFICATIONS
NOTE: For LP models an external regulator is required 
to reduce supply pressure to a maximum of 13" w.c.
IGNITION CONTROLS 
Piezo ignitor allows ignition of the pilot without the use of 
matches or batteries.
 Milli-Volt control has four (4) positions:
 
OFF  -  All gas to the gas logs is shut off at the 
valve.
 
IGN  -  Valve position to light/maintain a stand-
ing pilot.
 
ON  -  Valve position to turn ON/OFF log set 
with remote switch/thermostat.
 
LOW/HI  -  Variable position to control flame height 
(heat output). Both front and rear burn-
ers are in operation to provide realistic 
glow and yellow flame.
PILOT
The gas log heater is fitted with a specially designed safety 
pilot light which senses the amount of oxygen available in 
the room and shuts the gas log heater off if the oxygen level 
begins to drop below a satisfactory level. The pilot can only 
be relit when adequate fresh air is available.
THERMAL GENERATOR
The milli-volt gas log pilot is fitted with a milli-volt generator 
to provide power for remote activation.