Monessen Hearth HDV500NV/PV User Manual

40

System configuration/setup is done on the Command Center.

1.  Holding the ON button on the Command Center while turning on the master switch will toggle 

between standing pilot and intermittent pilot. 

.  After the above operation, one beep (for standing pilot) or two beeps (for intermittent pilot) will 

be given as confirmation.

1.  The system comes preset from the factory with a six (6) hour shutdown from its last command 

of operation. This is done to prevent the fireplace from continuing to operate if unattended. You 
may disable this feature if you wish.

Note: By disabling this feature, your fireplace may continue to operate unattended.
.  When the master switch is in the ON position (“-”), pressing the ON button and the OFF button 

on the Command Center simultaneously will toggle between enabling and disabling the six-
hour shutdown option. 

3.  After the above operation, one beep (for enabling the six-hour shutdown option) or two beeps 

(for disabling the six-hour shutdown option) will be given as confirmation.

1.  The RF receiver button located on the control board must be in the on position before the learn 

function can begin. Use paper clip to depress button. One beep for RF receiver ON or two 
beeps for RF receiver OFF will be given as confirmation.

.  After the RF receiver is on, holding the OFF button on the Command Center while turning on 

the master switch will activate the learn function for the transmitter. 

3.  After the above operation, two beeps will be given and the green LED on the Command Cen-

ter will flash for 10 seconds. 

4.  During the 10 seconds, press the OFF button on a transmitter to learn. Another two beeps will 

be given to confirm a successful learning.

To shut off the standing pilot for service or summer shut down, press and hold the ON button on 
the Command Center for 3 seconds when the master switch is in the ON position (“-”) and the 
main burner is off.
Note: Pilot will resume the next time system is turned on.

 

 

Intermittent/Standing 

Hold the ON ▲ button while turning on the master switch 

Intermittent

  Pilot Setup 

(Beep once for standing pilot, twice for intermittent pilot) 

Pilot

  Standing Pilot Temp. 

Hold the ON ▲ button 3 seconds (when the master switch

  Shutoff 

on the main burner is off)

  RF Remote Receiver 

Push the RF receiver On/Off button on the control board 

RF OFF   

  On/Off 

Beep once for ON and beep twice for OFF

  Learn Remote 

Hold the OFF ▼ button while turning on the master switch

  Transmitter 

(Beep twice then press any handheld remote button)

  6-hour safety  

Press the ON ▲ button and OFF ▼ button simultaneously 

ON

  shutdown setup 

(Beep once for ON, twice for OFF)