Monessen Hearth HDV500NV/PV User Manual
56D3048
7
HDV Series Direct Vent Gas Fireplace
PRe-INStAllAtIoN INFoRMAtIoN
BeFoRe you StARt
Read this homeowner manual thoroughly and follow all
instructions carefully. Inspect all contents for shipping
damage and immediately inform your dealer if any damage
is found. Do not install any unit with damaged, incomplete,
or substitute parts. Check your packing list to verify that
all listed parts have been received. You should have the
following:
instructions carefully. Inspect all contents for shipping
damage and immediately inform your dealer if any damage
is found. Do not install any unit with damaged, incomplete,
or substitute parts. Check your packing list to verify that
all listed parts have been received. You should have the
following:
•
Fireplace (Firebox and Burner System)
•
Log Set
•
Front Floor Brick ( pcs)
•
White Toggle Switch
•
Rock Wool
•
Non-Combustible Panel
•
Switch Cover Plate
•
Canopy
•
Restrictor Plate/Disc ()
IteMS RequIReD FoR INStAllAtIoN
•
Phillips Screwdriver
•
Framing Materials
•
Hammer
•
Wall Finishing Materials
•
Saw and/or saber saw
•
Level
•
Measuring Tape
•
Electric Drill and Bits
•
Tee Joint
•
Pliers
•
Square
•
Pipe Wrench
•
Fireplace Surround Material (Noncombustible)
•
Piping Complying with Local Codes
•
Pipe Sealant Approved for use with Propane/LPG
(Resistant to Sulfur Compounds)
N
ote
ColD ClIMAte INSulAtIoN
If you live in a cold climate, seal all cracks around your appliance, and
wherever cold air could enter the room, with noncombustible material.
It is especially important to insulate the outside chase cavity between
the studs and under the floor on which the appliance rests, if the floor
is above ground level.
wherever cold air could enter the room, with noncombustible material.
It is especially important to insulate the outside chase cavity between
the studs and under the floor on which the appliance rests, if the floor
is above ground level.
FIRePlACe FRAMING
Firebox framing can be built before or after the appliance
is set in place. Refer to Figure 2 for firebox and framing
dimensions. The framing headers may rest on the top of
the firebox standoffs.
The firebox may be installed directly on a combustible floor
or raised on a platform of an appropriate height. When
the firebox is installed directly on carpeting, tile, or other
combustible material, other than wood flooring, the firebox
shall be installed on a metal or wood panel extending the
full width and depth of the enclosure.
is set in place. Refer to Figure 2 for firebox and framing
dimensions. The framing headers may rest on the top of
the firebox standoffs.
The firebox may be installed directly on a combustible floor
or raised on a platform of an appropriate height. When
the firebox is installed directly on carpeting, tile, or other
combustible material, other than wood flooring, the firebox
shall be installed on a metal or wood panel extending the
full width and depth of the enclosure.