Monessen Hearth HVFL18 User Manual

Page of 44
32 
59D1015
Figure 44 - Location of Piezo Ignitor, Control Knobs and Switch  
on Milli-volt, Thermostat, and Manual Units
A. 
This appliance is equipped with a piezo ignition device which lights the pilot. If piezo is not working properly 
see Match Lighting Instructions, page 35.
B. 
BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because 
some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
  •  Do not attempt to light any appliance.
  •  Do not touch any electric switch; do not use any phone in your building.
  •  Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
  •  If you cannot reach your gas supplier, call the fire department.
C.  
Use only your hand to push in, or turn the gas control knob. Never use tools. If the knob will not push 
in or turn by hand, don't try to repair it. Call a qualified service technician. Force or attempted repair 
may result in a fire or explosion.
D. 
 Do  not  use  this  appliance  if  any  part  of  it  has  been  under  water.  Immediately  call  a  qualified  service 
technician  to  inspect  the  appliance  and  to  replace  any  part  of  the  control  system  and  any  gas  control 
that has been under water.
OPERATING INSTRUCTIONS
Piezo
Ignitor
Ignitor Pilot
Switch
If you do not follow these instruction 
exactly, a fire or explosion may result 
causing  property  damage,  personal 
injury or loss of life.
W
ARNING
 FOR YOUR SAFETY READ BEFORE LIGHTING 
Hi/Lo Knob