Monessen Hearth DBX24C* User Manual

32 

  1.  STOP! Read the safety information label.
  2.  Make sure the manual shutoff valve is fully open.
  3.  This gas log set is equipped with an ignition device (piezo) which automatically lights the pilot. If piezo 

ignitor does not light the pilot, See instructions for Match Lighting Instructions, page 32.

  4.  Turn gas control knob clockwise

 to the OFF position, set the thermostat to the lowest setting and turn 

ON/OFF switch to OFF position.

  5.  Wait (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! 

Follow "B" in the safety information label. If you don't smell gas, go to next step.

  6.  From OFF position, turn the gas control knob counterclockwise

 to IGN position. Push in control 

knob for 5 seconds.

  7.  With the control knob pushed in, push in and release the piezo ignitor button to light the pilot.
  8.  Continue pushing the control knob in for a further 60 seconds to prevent the flame detector from shutting off 

the gas while the probe is warming up. Release the control knob.

  9.  Turn gas control knob counterclockwise

 to the ON position.

 10.  After the pilot has been lit for one minute, the burners can be turned on. Turn the ON/OFF switch to ON 

position or adjust thermostat to desired setting.

 11.  If the gas logs will not operate, follow the instructions To Turn Off Gas To Appliance below and call your 

service technician or gas supplier.

  1.  Turn control knob clockwise

 to 

OFF position to completely shut off the heater.

  2.  If applicable: Turn ON/OFF switch to OFF position and/or set thermostat (if present) to lowest setting.
  3.  If applicable: Turn off all electric power to the heater.