Monessen Hearth LX36DV User Manual

Page of 48
4
51D0528
LX Series Direct Vent Gas Fireplace
14.  Do not use any solid fuels (wood, coal, paper, card-
board,  etc.)  in  this  fireplace.  Use  only  the  gas  type 
indicated on rating plate.
15.  This  appliance,  when  installed,  must  be  electrically 
grounded  in  accordance  with  local  codes  or  in  the 
absence  of  local  codes,  with  the  National  Electrical 
Code, ANSI/NFPA 70
, or the Canadian Electrical Code, 
CSA C22.1.
16.  Do not obstruct the flow of combustion and ventilation 
air in any way. Provide adequate clearances around 
air openings into the combustion chamber along with 
adequate  accessibility  clearance  for  servicing  and 
proper operation.
17.  When the appliance is installed directly on carpeting, 
tile  or  other  combustible  material  other  than  wood 
flooring, you must set appliance on a metal or wood 
panel or hearth pad extending the full width and depth 
of the appliance.
18.  Do not use fireplace if any part has been exposed to 
or  under  water.  Immediately  call  a  qualified  service 
person to arrange for replacement of the unit.
19.  Do not operate fireplace if any log is broken.
20.  Do not use a blower insert, heat exchanger insert, or 
any  other  accessory  not  approved  for  use  with  this 
fireplace.
21.  Do not operate the fireplace with glass door removed, 
cracked, or broken.   
22.  For  Massachusetts  Residents  only:  This  product 
must be installed by a licensed plumber or gas fitter 
when installed within the Commonwealth of Massa-
chusetts. Flexline installation must not exceed 36". 
coDe AppRoVAL 
Direct Vent type appliances draw all combustion air from outside of the dwelling through the vent pipe.
These appliances have been tested by CSA and found to comply with the established standards for DIRECT VENT GAS 
FIREPLACE HEATERS in the USA and Canada as follows:
LISteD VeNteD GAS FIRepLAce heAteR
TESTED TO: ANSI Z21.88-2009 / CSA 2.33-2009 STANDARDS 
IMpoRtANt SAFety INFoRMAtIoN
W
ARNING
Never connect unit to private (non-utility) 
gas wells.  this gas is commonly known 
as wellhead gas.
IMpoRtANt:
pLeASe ReAD the FoLLoWING 
cAReFuLLy 
It is normal for fireplaces fabricated of steel 
to give off some expansion and/or contraction 
noises during the start up or cool down cycle. 
Similar noises are found with your furnace heat 
exchanger or car engine. 
IMpoRtANt:
pLeASe ReAD the FoLLoWING 
cAReFuLLy 
It is not unusual for gas fireplace to give off 
some odor the first time it is burned. This is due 
to the manufacturing process. 
please ensure that your room is well 
ventilated during burn off — open all 
windows.
It is recommended that you burn your fireplace 
for at least ten (10) hours the first time you use 
it. Place the fan switch in the “OFF” position 
during this time.
WARNING
!
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
Nous recommandons que nos 
appareils de chauffage au gaz 
soient installés et entretenus par 
des professionnels qui ont été 
accrédités aux È.U. par le National 
Fireplace Institute ® (NFI) comme 
étant des spécialistes du NFI en 
matièred’appareils de chauffage 
au gaz.