Monessen Hearth KHLDV400 User Manual
4
73D0024
KHLDV Series Gas Fireplace
IMportant SaFety InForMatIon and coDe approVaL
Continued from page 3
15. This appliance, when installed, must be electrically
grounded in accordance with local codes or in the
absence of local codes, with the National Electrical
Code, ANSI/NFPA 70, or the Canadian Electrical Code,
CSA C22.1.
absence of local codes, with the National Electrical
Code, ANSI/NFPA 70, or the Canadian Electrical Code,
CSA C22.1.
16. Do not obstruct the flow of combustion and ventilation
air in any way. Provide adequate clearances around
air openings into the combustion chamber along with
adequate accessibility clearance for servicing and
proper operation.
air openings into the combustion chamber along with
adequate accessibility clearance for servicing and
proper operation.
17. When the appliance is installed directly on carpeting,
tile or other combustible material other than wood floor-
ing, you must set appliance on a metal or wood panel
or hearth pad extending the full width and depth of the
appliance.
ing, you must set appliance on a metal or wood panel
or hearth pad extending the full width and depth of the
appliance.
18. Do not use fireplace if any part has been exposed to
or has been under water. Immediately call a qualified
service technician to inspect the appliance and replace
any part of the control system and any gas control which
as been submerged in water.
service technician to inspect the appliance and replace
any part of the control system and any gas control which
as been submerged in water.
19. Do not operate fireplace if any log is broken.
20. Do not use a blower insert, heat exchanger insert, or
20. Do not use a blower insert, heat exchanger insert, or
any other accessory not approved for use with this
fireplace.
fireplace.
21. Do not operate the fireplace with glass door removed,
cracked, or broken.
coDe approVaL
Direct Vent type appliances draw all combustion air from outside of the dwelling through the vent pipe.
These appliances have been tested by CSA and found to comply with the established standards for
DIRECT VENT GAS FIREPLACE HEATERS in the USA and Canada as follows:
These appliances have been tested by CSA and found to comply with the established standards for
DIRECT VENT GAS FIREPLACE HEATERS in the USA and Canada as follows:
LISteD VenteD GaS FIrepLace Heater
TESTED TO: ANSI Z21.88-2009 / CSA 2.33-2009 STANDARDS
A manufactured home (USA only) or mobile home OEM installation must conform with the Manufactured
Home Construction and Safety Standard, title 24 cFr, part 3280, or when such a standard is not
applicable, the Standard for Manufactured Home Installations, anSI/ncSBcS a225.1, or Standard
for Gas equipped recreational Vehicles and Mobile Housing, cSa Z240.4.
Home Construction and Safety Standard, title 24 cFr, part 3280, or when such a standard is not
applicable, the Standard for Manufactured Home Installations, anSI/ncSBcS a225.1, or Standard
for Gas equipped recreational Vehicles and Mobile Housing, cSa Z240.4.
WARNING
!
HOT GLASS WILL
CAUSE BURNS.
DO NOT TOUCH GLASS
UNTIL COOLED.
NEVER ALLOW CHILDREN
TO TOUCH GLASS.
w
arn
In
G
never connect unit to private (non-
utility) gas wells. this gas is commonly
known as wellhead gas.
utility) gas wells. this gas is commonly
known as wellhead gas.
IMportant:
pLeaSe reaD tHe FoLLowInG
careFuLLy
It is normal for fireplaces fabricated of steel to give off
some expansion and/or contraction noises during the
start up or cool down cycle. Similar noises are found with
your furnace heat exchanger or car engine.
some expansion and/or contraction noises during the
start up or cool down cycle. Similar noises are found with
your furnace heat exchanger or car engine.
IMportant:
pLeaSe reaD tHe FoLLowInG
careFuLLy
It is not unusual for gas fireplaces to give off some odor
the first time it is burned. This is due to the manufacturing
process.
the first time it is burned. This is due to the manufacturing
process.
please ensure that your room is well ventilated
during burn off — open all windows.
It is recommended that you burn your fireplace for at
least ten (10) hours the first time you use it. Place the
fan switch in the “OFF” position during this time.
least ten (10) hours the first time you use it. Place the
fan switch in the “OFF” position during this time.