Monessen Hearth 624DV(ST User Manual

Page of 52
42D0200
Designer Series Gas Fireplaces
31
LoG PLaCEMENT
INSTaLL LoGS aNd RoCK wooL (EMBER MaTERIaL) IN FIREBox
1.  Remove glass frame. Refer to Glass Frame Removal, Page 31.
2.  Carefully remove logs from wrapping.
3.  Place left log (#1) on left end of grate. Line up two (2) pin holes in bottom of log with two (2) pins 
on grate. Log #1 will always be to the left of the control panel. Figure 41 
4.  Place right log (#2) on right end of grate. Line up three (3) pin holes in bottom of log with three 
(3) pins on grate. Figure 42
Before you begin — This unit is supplied with eight ceramic fiber logs. Do not handle these logs 
with your bare hands. always wear gloves to prevent skin irritation from ceramic fibers. After 
handling the logs, wash your hands gently with soap and water to remove any traces of fibers.
LG639
DV6000 right log
Figure 42 - 
Install Right Log (#2)
Right Log 
(#2)
Pins
Control Panel 
w
a
RNING
The  positioning  of  the  logs  is  critical  to  the  safe  and  clean 
operation of this heater. Excessive sooting and other problems 
may result if the logs are not properly and firmly positioned in the 
appliance. Never add additional logs or embellishments such as 
pine cones or vermiculite to the heater. only use the logs supplied 
with the unit. 
Failure to position the parts in accordance with diagrams below or 
to use only parts specifically approved for this heater may result 
in property damage or personal injury.
LG638
DV6000 left log
Figure 41 - 
Install Left Log (#1)
Left Log 
(#1)
Grate 
Pins
Control Panel 
LG638