Monessen Hearth BDV500 User Manual
54D0700
37
ON
OFF
PILOT
LO
HI
Figure 47 - Electronic Gas Valve
OPERATING INSTRUCTIONS (ELECTRONIC)
LIGHTING ELECTRONIC IGNITION
A.
This appliance is equipped with an ignition device
(Piezo) which automatically lights the pilot. Do
NOT try to light the burner by hand.
(Piezo) which automatically lights the pilot. Do
NOT try to light the burner by hand.
B.
BEFORE OPERATING smell all around the appli-
ance area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.
ance area for gas. Be sure to smell next to the floor
because some gas is heavier than air and will settle
on the floor.
WHAT TO DO IF YOU SMELL GAS:
• Turn off all gas to the appliance.
• Open
windows.
• Do not attempt to light any appliance.
• Do not touch any electric switch; do not use any phone in your building.
• Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions.
• If you cannot reach your gas supplier, call the fire department.
C.
Turn off all electric power to appliance.
D.
Do not use this appliance if any part of it has been under water. Immediately call a qualified service tech-
nician to inspect the appliance and to replace any part of the control system and any gas control that has
been under water.
been under water.
If you do not follow these instructions
exactly, a fi re or explosion may result
causing property damage, personal
injury or loss of life.
exactly, a fi re or explosion may result
causing property damage, personal
injury or loss of life.
W
ARNING
FOR YOUR SAFETY READ BEFORE LIGHTING
TO TURN OFF GAS
Never use an open fl ame
to check for gas leak.
to check for gas leak.
WARNING
1. Open lower door.
2. Turn RS-OFF_ON rocker switch to “OFF”.
3. Turn off all electric power to the appliance if service is to be performed.
4. Close lower door.
2. Turn RS-OFF_ON rocker switch to “OFF”.
3. Turn off all electric power to the appliance if service is to be performed.
4. Close lower door.
1. STOP! Read the safety information above.
2. Make sure all power to unit is turned off.
3. Set thermostat to lowest setting.
4. This appliance is equipped with an ignition device which
2. Make sure all power to unit is turned off.
3. Set thermostat to lowest setting.
4. This appliance is equipped with an ignition device which
automatically lights the burner. Do not try to light the
burner by hand.
burner by hand.
5. Turn on all electric power to appliance.
6. Set thermostat to desired setting.
7. Turn RS-OFF-ON rocker switch to “ON”.
6. Set thermostat to desired setting.
7. Turn RS-OFF-ON rocker switch to “ON”.
8. If the appliance will not operate, follow the instruction
To Turn Off Gas
below
and call your service techni-
cian or gas supplier.