Hearth & Home Technologies RHW-485H User Manual

Heat & Glo • RHW-485 • 33221 Rev O • 08/06

4

This fi replace system has been tested and listed in accor-
dance with UL 127 and ULC-S610 standards by Underwrit-
ers Laboratories Inc. for installation and operation in the 
United States and Canada.

This fi replace has been tested and listed for use with the op-
tional components specifi ed in this manual. These optional 
components may be purchased separately and installed at 
a later date. Installation of an outside air kit will require sig-
nifi cant reconstruction and is best if installed at the time of 
fi replace installation.

Heat & Glo is a registered trademark of Hearth & Home 
Technologies Inc.

This fi replace is tested and approved as a decorative fi re-
place. It should not be factored as a primary heat source 
in residential heating calculations.

Improper installation, adjustment, alteration, service 

or maintenance can cause injury or property damage. 

Refer to the owner’s information manual provided with 

this fi replace. For assistance or additional information 

consult a qualifi ed installer, service agency or your 

dealer.

•  Do not install or operate damaged fi replace.
•  Do not modify fi replace.
•  Installation other than as instructed by Hearth & Home 

Technologies Inc. is strictly prohibited.

•  Do not operate the fi replace without fully assembling 

all components.

•  Do not overfi re. 
•  Do not install an unvented gas log set. This fi replace 

has not been tested for use with unvented gas log 
sets.

•  Installation and/or use of any component part not 

approved by Hearth & Home Technologies.

Hearth & Home Technologies disclaims any responsibility 
for, and the warranty and agency listing will be voided by 
the above actions.