Hearth & Home Technologies SAPPH-D-CWL User Manual

         September 1, 2008

Page  33

Quadra-Fire · Sapphire · 250-7233H

Refer to Section 12 for specific color part numbers.

Hearth legs will allow three additional inches of clearance.  
Be sure to calculate this distance correctly if necessary to 
cut wall hole to install horizontally.  Refer to Dimensions on 
in Section 12.

To change legs, use a 1/2 in. wrench to remove and replace 
one leg at a time while the appliance is in an upright 
position.

While still breakable, the logs do not become fragile until 
after the appliance is burned and they have cured.  After 
curing, any handling must be done with care as breakage 
can easily occur.

   The log set is packed in the components box and 

consists of the following:

Set the rear log on the three locator pins in the 

back of the firebox.

Set left and right partial logs (with butt end towards 

the side of the appliance firebox) in the grooves provided on 
the burner surface.

Locate the pin hole on the bottom of the right and left twigs 
and situate them over the white pins, one is located on the 
rear log and the other is on the right partial log.

1

Rear Log

3

1

Left Partial Log

1

1

Right Partial Log

5

1

Left Twig

2

1

Right Twig

4