Hearth & Home Technologies SFE-CDLB3530PP User Manual

Page of 9
Hearth & Home Technologies Inc. • Plug & Play • 4050-317 Rev A • 04/08
3
When using electrical heaters, basic precautions should always be followed to reduce the risk of fi re, electric shock and 
injury to persons, including the following:
•  To prevent a possible fi re, do not block air intakes or 
exhaust in any manner.
•  A heater has hot and arcing or sparking parts inside. Do 
not use it in areas where gasoline, paint, or fl ammable 
liquids are used or stored.
•  Use this heater only as described in this manual. Any 
other use not recommended by the manufacturer may 
cause fi re, electric shock, or injury to persons.
•  Always use properly grounded, fused and polarized 
outlets.
•  Always use ground fault protection where required by 
electrical code.
•  Always disconnect power before performing any cleaning, 
maintenance or relocation of the heater.
•  To prevent a possible fi re, do not burn wood or other 
materials in this heater.
•  To prevent electric shock or fi re, always use a certifi ed 
electrician should new circuits or outlets be required.
•  When transporting or storing the heater, keep in a dry 
place free from excessive vibration and store to avoid 
damage.
•  Avoid the use of an extension cord because the extension 
cord may over heat and cause a risk of fi re.  However, 
if you have to use an extension cord, the cord shall be 
No. 16 AWG minimum size and rated not less than 1875 
watts.
•  SAVE THESE INSTRUCTIONS FOR FUTURE 
REFERENCE.
•  Read all instructions before using this heater.
•  This heater is hot when in use. To avoid burns do not let 
bare skin touch hot surfaces. If provided, use handles 
when moving this heater. Keep combustible materials, 
such as furniture, pillows, bedding, papers, clothes and 
curtains away from sides and rear of heater, and at least 
36 in. (914 mm) from the front.
•  Extreme caution is necessary when any heater is used 
by or near children or invalids and whenever the heater 
is left operating and unattended.
•  Always unplug heater when not in use.
•  Do not operate any heater with a damaged cord or plug 
or after the heater malfunctions, has been dropped or 
damaged in any manner. Return heater to authorized 
service facility for examination, electrical or mechanical 
adjustment, or repair.
•  Do not use outdoors.
•  This heater is not intended for use in bathrooms, laundry 
areas and similar indoor locations. Never locate heater 
where it may fall into a bathtub or other water container.
•  Do not run cord under carpeting. Do not cover cord with 
throw rugs, runners, or the like. Arrange cord away from 
traffi c areas and where it will not be tripped over. Do not 
coil cord.
•  To disconnect heater, turn controls to “OFF” then remove 
plug from outlet.
•  Do not insert or allow foreign objects to enter any 
ventilation or exhaust opening as this may cause an 
electric shock or fi re, or damage the heater.
1
 
Important Instructions 
WARNING! Risk of Fire!
DO NOT:
•  install or operate damaged heater
• modify 
heater
•  operate the heater without fully assembly all 
components
The following actions are strictly prohited:
•  Installation other than as instructed by Herath & Home 
Technologies Inc. 
•  Installation and/or use of any component part not 
approved by Hearth & Home Technologies Inc.
Hearth & Home Technologies Inc. disclaims any responsibility 
for, and the warranty and agency listing will be voided by the 
above actions.
WARNING! Improper installation, adjustment, altera-
tion, service or maintenance can cause injury or prop-
erty damage. 
Refer to the owner’s information manual 
provided with this heater. For assistance or additional 
information consult a qualifi ed installer, service agency or 
your dealer.
NOTICE! This fi replace is not intended for use as a primary 
heat source and should not be factored as such in residential 
heating calculations.