Hearth & Home Technologies Everest User Manual

Heat & Glo  •  Everest  •  750-900  Rev. o  •  10/08

26

Combustible materials may be brought up to the specifi ed 
clearances on the side and top front edges of the fi replace, 
but MUST NEVER overlap onto the front face. The joints 
between the fi nished wall and the fi replace top and sides 
can only be sealed with a 300° F. (149° C) minimum 
sealant.

Install optional marble and brass trim surround kits as 
desired. Marble, brass, brick, tile, or other non-combustible 
materials can be used to cover up the gap between the 
sheet rock and the fi replace.

If the gas logs have been factory installed they should not 
need to be positioned. If the logs have been packaged 
separately, refer to the instructions that accompany the 
logs. Save the log instructions with this manual.

If sooting occurs, the logs might need to be repositioned 
slightly to avoid excessive fl ame impingement.

A bag of rock is shipped with this fi replace. Refer to the 
placement instructions on the back of the log placement 
instructions.

Ember material is shipped with this gas fi replace. The bag 
labeled Glowing Ember (050-721) is standard glowing 
ember material. To place the ember material:

•  Pull the six glass latches out of the groove on the glass 

frame. Remove the front trim door and the glass door 
from the unit.

•  Cover the top of the burner with a single layer of ember 

material. For best performance do not place embers di-
rectly on the ports. Save the remaining ember materials 
for use during fi replace servicing.

•  Replace the glass door and a front trim door on the unit 

(see Service Parts List of this manual.)

•  Pull out and latch the glass clips into the groove on the 

glass frame.