Hearth & Home Technologies GARNET-MBK User Manual
September 1, 2008
Page 31
Quadra-Fire · Garnet-T · 7016-127F
8
Appliance Setup
A. Remove Shipping Materials
Remove shipping materials from inside or underneath the
firebox.
firebox.
B. Leg Leveling System
Figure 8.1
Thread Allen bolts through nuts until flush. The
Allen bolts and nuts are included in the component pack inside
the appliance firebox.
the appliance firebox.
Figure 8.2
Slide assembled nuts and bolts into the slots on
the legs with the nuts on the bottom.
Figure 8.3
Use a 5/32 in. 4mm) Allen wrench to adjust legs
up and down to desired level.
C. Flue Restrictor Installation
Figure 8.4
Installation of the flue restrictor requires the
removal of the baffle located inside the firebox. Remove the
baffle by first removing the two screws holding the baffle in
place (one on each side). Lift the baffle out of the bracket
along the back of the firebox, angle the baffle slightly and
remove it from the firebox.
baffle by first removing the two screws holding the baffle in
place (one on each side). Lift the baffle out of the bracket
along the back of the firebox, angle the baffle slightly and
remove it from the firebox.
Figure 8.5
With the baffle removed, remove the two screws
located in the back of the firebox. Reuse the screws to install
the flue restrictor.
the flue restrictor.
When your installation falls within a shaded area on the
vent graph (page 11) a flue restrictor must be installed
for proper operation.
vent graph (page 11) a flue restrictor must be installed
for proper operation.