Hearth & Home Technologies TOPAZ-D-CWL User Manual

Page  34

September 1, 2008

Quadra-Fire · Topaz · 7009-113G

NOTE:  This blower utilizes a snap disc to control ON and 
OFF operation. When the correct temperature is reached, 
the blower will automatically turn ON. Use the rheostat knob 
to adjust the fan to High or Low to suit your preferences.

Install speed control to switch panel.  Attach knob 

to speed control.

Reinstall rear shield.  Connect blower to power 

supply and turn on gas supply.

FROM THE KIT YOU WILL NEED: Blower motor; snap 
disc bracket with wire harness; rheostat, rheostat nut; knob; 
screws; 1 zip-tie.  

Turn off gas supply, (if gas is connected,) and 

remove rear shield. Remove blower from packaging. Place 
blower under appliance.  Attach blower from front with 4 
screws to blower bracket. 

Install snap disc in bracket. Attach bracket to fire-

box with 5/16 in. wrench. 

Connect electrical connector to snap disc. 

TOOLS REQUIRED:  #2 Phillips head bit; hand drill; 11/16 
in. wrench; and a 5/16 in. wrench.

Attach with 4 
screws

Snap Disc
Bracket 

5/16" nut 

Remove the glass door assembly by opening latches at the 
bottom front of the appliance, on both the left and right sides. 
Lift out and away from the appliance.

Replace with a new glass door assembly.

Handle glass assembly with care.

•  Inspect the gasket to ensure it is undamaged.
•  Inspect the glass for cracks, chips or 

scratches.

•  Do NOT strike, slam or scratch glass.
•  Do NOT operate appliance with glass door 

removed, cracked, broken or scratched.

•  Replace glass assembly as a complete 

assembly.