Hearth & Home Technologies TIARAI-CTO User Manual

August 1, 2008

Page  31

Heat & Glo · Tiara I B & Tiara II B · 7010-149M

   Insert inner collar adapter to rear fl ue vent.

   Install vent pipe adapter with gasket or high-temp 

sealant to rear vent opening.  Attach with screws removed 
in Figure 8.5.  

Place an appropriate grille (without a hole) gently into the 
opening on top of appliance.  (RV-GRILLE-T1 for the Tiara 
I-B and RV-GRILLE-T2 for the Tiara II-B.)

Refer to vent graph on page 12.  If your installation falls 
within the range of the gray shaded area of graph, it may be 
necessary to make an adjustment to the vertical damper to 
improve the flame appearance in your appliance.

1. 

Loosen screws using a Phillips head screwdriver.

2.  Pivot the vertical damper adjustor in 1/4 in. (6mm) 

increments while observing the activity.

3. 

Turn clockwise to open the damper = less fl ame height 
and more blue in fl ame color.

4.  Turn counterclockwise to close damper = increased 

fl ame height and more yellow in fl ame color.

5. Make 

adjustment 

until 

fl ame size and activity suit your 

personal preference and then retighten screws on the 
adjustment control.

OPEN

CLOSED

  Locate the damper adjustment on the intake 

plenum, accessing through the appliance front.  Adjustor is 
centered at the top of the appliance.

   The rear vent damper is located in the back of 

the firebox (behind the rear brick panel on the Tiara II-B.  It is 
recommended to make adjustment prior to installation. 

1. 

Remove front/glass/ logs and brick (if installed).

2. 

Loosen screws and slide up to suggested settings.

3. Tighten 

screws 

4. 

Reinstall front/glass/logs and brick (if applicable).

NOTE: In the Commonwealth of Massachusetts, the word 
damper shall be replaced with the words flue restrictor.

   Place cover plate and gasket over top vent and 

attach with the eight screws removed in Figure 8.2.