Hearth & Home Technologies TIARA II-B User Manual

August 1, 2008

Page 25

Heat & Glo · Tiara I B & Tiara II B · 7010-149M

MILLIVOT GENERATOR

THERMOCOUPLE

PILOT HOOD

Figure 6.4

Pull off pilot hood and set aside.

NOTE: Do not remove retaining clip from hood.

5/32 in. Allen wrench

Figure 6.5

Use a 5/32 in. Allen wrench to remove the pilot injec-

tor. Replace pilot injector with the one supplied with the
appliance (#35 for Propane, #62 for Natural Gas).

Replace pilot hood, snapping into position.

Figure 6.6

Remove main burner orifi ce using a 5/8 in. wrench.

Replace orifi ce with the proper size as indicated on for your
gas type and venting.

PROPANE

NATURAL GAS

Tiara I-B

.063

.106

Tiara II-B

.073

.120

Reinstall burner by placing it into the fi rebox.

Tiara I-B: Installation is the reverse of the removal. DO NOT
OVERTIGHTEN. Reinstall the optional brick set, if applica-
ble.

Tiara II-B: Installation is the reverse of the removal. Make
sure to reinstall the two 1/4 in. x 20 screws that secure the
burner.

Reinstall logs, glass and front.

Figure 6.6

Turn control knob to the OFF position, ensure that

gas supply to the valve has been turned off. Using a Torx
TH20, or slotted screwdriver, remove the three pressure
regulator mounting screws

(1), pressure regulator tower (2),

and diaphragm

(3).

2. Valve Regulator Replacement

Remove upper and lower back shield. Loosen the set col-
lars on the extension rods with the 3/32 in. Allen wrench.
Remove the rods and adapter cap.

Fire Risk.
Explosion Risk.
• Disconnect any electrical cords and

turn off gas supply to unit before
proceeding if converting fuel on an
appliance already fully installed.

WARNING

Tiara I-B and Tiara II-B:

Mounting Screws

Pressure Regulator Tower

Diaphragm