Hearth & Home Technologies TOPAZ-D-CSB User Manual

Page  32

September 1, 2008

Quadra-Fire · Topaz · 7009-113G

NOTE: Side brick panels will fit only if installed at an angle. 
Do not attempt to push the brick flat against the outer wall 
of the firebox. Brick should rest against spacer on inside of 
firebox.

   Install left or right side panel. Place in lower chan-

nel and rotate into place. 

   Bend over tabs to hold panel in place.

Install the top panel/baffle.  If rear venting, set damper prior 
to installing the top panel/baffle.  (In the Commonwealth of 
Massachusetts, the word damper shall be replaced with the 
word damper shall be replaced with the words flue restrictor.) 
The back edge will slide in front of the rear brick panel. Rest 
one end of the top panel/baffle on the installed side panel 
and support the other end with one hand.

Install the remaining side panel and bend over the tabs to 
hold it in place.  Rest top panel/baffle on sides and slide top 
panel/baffle left or right until centered.

   Fully installed brick set. Note that with the brick 

installed the firebox is narrower at the back than in the 
front.

While still breakable, the logs do not become fragile until 
after the appliance is burned and they have cured.  After 
curing, any handling must be done with care as breakage 
can easily occur.

   The log set is packed in the components box and 

consists of the following:

1

Rear Log

1

1

Left Front Log

2

1

Right Front Log

3

1

Left Twig

4

1

Right Twig

5