Hearth & Home Technologies SL-750TV-D User Manual

Heat & Glo  •  SL-550 / 750 / 950TV-D  •  2053-985 Rev. H  •  9/06

30

Pull the four glass assembly latches out of the groove on 
the glass frame. Remove glass door from the appliance 
(see Figure 12.17).

Replace the glass door on the appliance. Pull out and 
latch the four glass assembly latches into the groove on 
the glass frame.

Handle glass doors with care.

•  Inspect the gasket to ensure it is 

undamaged.

•  Inspect the glass for cracks, chips or 

scratches.

•  Any scratch in glass, requires replacement.

•  Do NOT strike, slam or scratch glass.

•  Do NOT operate appliance with glass door removed, 

cracked, broken or scratched.

•  Replace glass door assembly as a complete appliance.

The screen mesh is a protective barrier and must be 
attached.

Install optional marble and brass trim surround kits as 
desired. Marble, brass, brick, tile, or other non-combustible 
materials can be used to cover up the gap between the 
sheet rock and the appliance.

Do not obstruct or modify the air inlet/outlet grilles or hood. 
When overlapping on both sides, leave enough space so 
that the bottom grille can be lowered and the trim door 
removed.

Hood is included with the front and required in all 
installations. 

Place log #6 so that the right edge fi ts into the notch on log #5, the middle goes 

into the tab on log #1, and the left edge rests on log #3.

6

SL-550TV-D

1/4 in.

3/8 in.

SL-750TV-D

1/4 in.

3/8 in.

SL-950TV-D

3/8 in.

Full open