Hearth & Home Technologies 5100I-NL-B User Manual
5100-I ACT WOOD INSERT
Page 0
September 1, 2008
R
438-0380D
D. Door Handle Assembly Replacement
1. Install washer on door handle shaft.
2. Slide door handle through door.
3. Install second washer(s) as shown.
. Install key in groove.
5. Align groove in latch cam with key; slide latch cam
2. Slide door handle through door.
3. Install second washer(s) as shown.
. Install key in groove.
5. Align groove in latch cam with key; slide latch cam
over shaft
6. Install locknut.
. Install spring handle turning in a counter-clockwise
. Install spring handle turning in a counter-clockwise
motion to desired location on handle.
CAUTION
• Do NOT overtighten lock nut.
• Door handle needs to move smoothly.
Locknut
Door Cross
Section
Latch Cam
Spacing Washers
Square Key
Door Handle
Spring Handle
C. Glass Replacement - Side Window
• Frequency: As needed
• By: Homeowner / Qualified service technician
• Task: See the following instructions.
• By: Homeowner / Qualified service technician
• Task: See the following instructions.
1. Open door and remove vertical brick in the bay
window area.
. Reach inside firebox and loosen hex bolts using a
/8 inch socket wrench holding the cast in place.
3. Only remove the 2 bolts, top and bottom on the side
closest to the firebox opening.
Figure 30.1
4. Open the side of the window where the bolts have
been removed and slide out glass.
5. Slide new glass in making sure it slides into the cast
grooves.
6. Re-assemble in reverse order. Do not overtighten
bolts.
• Frequency: As needed
• By: Homeowner / Qualified service technician
• Task: See the following instructions.
• By: Homeowner / Qualified service technician
• Task: See the following instructions.
Figure 30.2
Loosen
bolts
Remove
bolts
Slide Window In / Out
Figure 30.1