Enviro DV50DX User Manual

Figure 41: Once the logs are in place the embers can be placed onto and around the burner to create

a realistic look. Bags of ceramic fiber embers and rock wool are provided. The ceramic fiber comes in

chunks that are about 2” (51 mm) long. Place them irregularly around the burner. When there is a

sparse but even layer of embers, spread the rock wool in the same manner. DO NOT pack this ember

material as this could create an

unsafe condition. The pieces

should be lightly placed so they

don’t completely block any of

the small burner ports. DO NOT

allow any of the embers to rest

against the pilot assembly.

Caution: Use only the type of

ember material supplied with this

fireplace. Due to the irregular

size of the ember material, there

may be more than required. Use

of other foreign materials on the

burners may create dangerous

conditions.

Figure 41. Complete log set-up with embers.

Figure 42. DV50DX complete log set-up with embers burning.

Figure 42: The DV50DX

burning with a good flame.

NOTE: While the glass is still

removed, it is recommended

that the gas line be purged

by lighting the pilot.

When lighting the fireplace

for the first time since the

log set and embers have

been

installed/replaced,

watch for ignition at ALL

the burner ports. If a long

delay is noticed, turn the

appliance off and wait for it

to cool down. Then remove

the glass and rearrange the

ember material, making

sure none of the burner

ports are blocked.

Secondary Installation