Hearth & Home Technologies Bravo User Manual
Hearth & Home Technologies • Bravo, Aztec • InD • 703-900 Rev. N • 8/06
26
NOTE: Have the gas supply line installed in accordance
with local building codes, if any. If not, follow ANSI
223.1. Installation should be done by a qualifi ed installer
approved and/or licensed as required by the locality. (In
the Commonwealth of Massachusetts installation must be
performed by a licensed plumber or gas fi tter.)
with local building codes, if any. If not, follow ANSI
223.1. Installation should be done by a qualifi ed installer
approved and/or licensed as required by the locality. (In
the Commonwealth of Massachusetts installation must be
performed by a licensed plumber or gas fi tter.)
A. Fuel Conversions
WARNING
Fire Risk.
Explosion Hazard.
High pressure will damage valve.
• Disconnect gas supply piping BEFORE
Explosion Hazard.
High pressure will damage valve.
• Disconnect gas supply piping BEFORE
pressure testing gas line at test pressures
above 1/2 psig.
above 1/2 psig.
• Close the manual shutoff valve BEFORE
pressure testing gas line at test pressures
equal to or less than 1/2 psig.
equal to or less than 1/2 psig.
B. Gas Pressures
C. Gas Connection
WARNING
Verify inlet pressures.
• High pressure may cause overfi re
• High pressure may cause overfi re
condition.
• Low pressure may cause explosion.
• Verify minimum pressures when other
• Verify minimum pressures when other
household gas appliances are operating.
Install regulator upstream of valve if line
pressure is greater than 1/2 psig.
pressure is greater than 1/2 psig.
Proper input pressures are required for optimum appliance
performance. Gas line sizing requirements need to be
made following NFPA51.
performance. Gas line sizing requirements need to be
made following NFPA51.
Gas Information
9
NOTE: Gas line may be run from either side of the appliance
provided the hole in the outer wrap does NOT exceed 2-1/2
inches in diameter and does not penetrate the fi rebox.
provided the hole in the outer wrap does NOT exceed 2-1/2
inches in diameter and does not penetrate the fi rebox.
NOTE: A listed (and Commonwealth of Massachusetts ap-
proved) 1/2 inch (13mm) T-handle manual shut-off valve and
fl exible gas connector are connected to the 1/2 inch (13mm)
control valve inlet.
• If substituting for these components, please consult
proved) 1/2 inch (13mm) T-handle manual shut-off valve and
fl exible gas connector are connected to the 1/2 inch (13mm)
control valve inlet.
• If substituting for these components, please consult
local codes for compliance.
Pressure requirements for appliance are shown in the
table below. Minimum pressures must be met when other
household gas appliances are operating.
table below. Minimum pressures must be met when other
household gas appliances are operating.
Pressure Natural
Gas
Propane
Minimum
5.0 inches
11.0 inches
Inlet Pressure
w.c.
w.c.
Maximum Inlet
14.0 inches
14.0 inches
Gas Pressure
w.c.
w.c.
Manifold
3.5 inches
10.0 inches
Pressure w.c. w.c.
Before making gas connections ensure that appliance be-
ing installed is compatible with the available gas type.
ing installed is compatible with the available gas type.
Any natural or propane gas conversions necessary to
meet the appliance and locality needs must be made by
a qualifi ed technician using Hearth & Home Technologies
specifi ed and approved parts.
meet the appliance and locality needs must be made by
a qualifi ed technician using Hearth & Home Technologies
specifi ed and approved parts.
Refer to Reference Section 16 for location of gas line
access in appliance.
access in appliance.
WARNING
Gas Leak Risk
• Support control when attaching pipe to
• Support control when attaching pipe to
prevent bending gas line.
NOTE: The gap between supply piping and gas ac-
cess hole may be caulked with high temperature caulk
or stuffed with non-combustible, unfaced insulation to
prevent cold air infi ltration.
cess hole may be caulked with high temperature caulk
or stuffed with non-combustible, unfaced insulation to
prevent cold air infi ltration.