Hearth & Home Technologies Bravo User Manual

Hearth & Home Technologies  •  Bravo, Aztec  •  InD  •  703-900  Rev. N  •  8/06

30

WHT

WHT

BLK

BLK

If the box is being wired from the OUTSIDE of 
the appliance:

•  Remove the cover plate located on the outer 

shell - right side (see Figure 10.3).

•  Install the supplied Romex

™ 

connector in the 

cover plate.

•  Feed the necessary length of wire through the 

connector.

•  Make all necessary wire connections and reat-

tach the cover plate  to the outer shell.

If the box is being wired from the INSIDE of the 

If the box is being wired to a wall 
mounted switch for use with a fan (See 
Figure 10.4):

•  The power supply for the appliance 

must be brought into a switch box.

•  The power can then be supplied from 

the switch box to the appliance using 
a minimum of 14-3 with ground wire.

•  At the switch box connect the black 

(hot) wire and red (switch leg) wire to 
the wall switch as shown.

•  At the appliance connect the black 

(hot), white (neutral) and green 
(ground) wires to the junction box as 
shown.

•  Add a 1/4 inch insulated female con-

nector to the red (switch leg) wire, 
route it through the knockout in the 
face of the junction box, and connect 
to the top fan switch connector (1/4 
inch male) as shown.

•  Feed the necessary length of wire through the connector.

•  Make all necessary wire connections to the junction box/re-

ceptacle and assemble the junction box/receptacle to the outer 
shell.

appliance:

•  Remove the screw attaching the junction 

box/receptacle  to the outer shell, rotate the 
junction box inward to disengage it from the 
outer shell (see Figure 10.3).

•  Pull the electrical wires from outside the ap-

pliance through this opening into the valve 
compartment.

NOTE: Do NOT wire 
110VAC to wall switch.