Enviro Omega User Manual
Routine Cleaning and Maintenance
EXHAUST PASSAGES (Biannually)
1. Open the firebox door by lifting the
1. Open the firebox door by lifting the
handle.
2. Remove the burn pot assembly and
clean all the parts.
3. Lubricate all screws with penetrating
oil.
4. Using a 3⁄8” socket, remove the two
(2) bolts that hold the firebox liner
in place. Vacuum the firebox and
firebox liner thoroughly.
5. Open the ash box door; remove the
ash box and cleanout the cavity.
6. Clean out the transition box to the
combustion blower (located behind
the ash box)
7. Re-install the ash box, firebox liner,
burn pot, and burn pot liner
8. Close the firebox and ash pan doors
and secure.
BLOWER MECHANISMS (Annually)
Unplug the stove then open the right
Unplug the stove then open the right
and left side panels to access the two
blowers. Remove the two (2) T-20 Torx
12
Ash Box
Burn Pot Assembly
Firebox Liner
Figure 10: Omega Exhaust Passages.
screws on the back of the each panel. and loosen the two (2) T-20 Torx screws on the front edge of
the panel Vacuum all dust from motors. The blower motors’ has sealed bearings, DO NOT lubricate this
motor. Check gaskets and replace if needed.
POST SEASON CLEAN-UP
Once you are finished using the pellet appliance for the season, unplug the stove for added electrical
Once you are finished using the pellet appliance for the season, unplug the stove for added electrical
protection. It is very important that the stove be cleaned and serviced as stated above.
CLEANING PAINTED SURFACES
Please clean painted surfaces with a soft damp cloth.
Please clean painted surfaces with a soft damp cloth.
FIREBOX LINER
The paint on the Firebox Liner may peel. This is due to extreme conditions applied to the paint and is in
The paint on the Firebox Liner may peel. This is due to extreme conditions applied to the paint and is in
no way covered by warranty.
DOOR GLASS REPLACEMENT
It is recommended that your dealer replace the glass if broken. The door glass is made of high temperature
It is recommended that your dealer replace the glass if broken. The door glass is made of high temperature
PYRO CERAMIC. To replace the glass, unscrew and remove the six (6) retainer nuts using a
5
/
16
” socket.
Remove the glass and any broken pieces. High temperature fiberglass tape should be used around the
glass in the same location as the original fiberglass. Insert the glass into the retainer, screw the inner door
to the retainer, install inner door assembly into outer door and gently tighten nuts. The use of substitute
materials is prohibited: #50-1673 Glass 117⁄8” x 153⁄8” (301.6mm x 390.5mm).