Desa 000-30 User Manual

117240-01C

5

1.  Check heater for damage. If heater is damaged,

promptly inform dealer where you bought

heater.

2.  Follow all of the safety and operating pre-

cautions.

3.  Check the "O" ring on the POL before each

use. Replace the "O" ring if there is any sign

of wear or damage.

4.  Make sure heater regulator knob is in the

"OFF" position.

5.

Attach the heater to

the guard on the propane/LP cylinder with the

support arm on the inside of the guard and bolts

through two holes in the guard (see Figure 5).

Tighten the support arm bracket into place us-

ing the wing nuts provided.

6.

 Connect  the  POL  fitting

at regulator to the propane/LP cylinder by

rotating the POL nut counter clockwise into

the propane/LP cylinder's valve outlet and

securely tighten with a wrench.

7.  Securely tighten all gas connections.

8.  Open the cylinder's gas valve and check all

connections for leaks. Apply mixture of liquid

soap and water to gas joints. Bubbles forming

show a leak that must be corrected. DO NOT

USE A FLAME.

Regulator

Support 
Arm

Bolt

Support Arm 
Bracket

Red Button 
on Safety 
Valve

Read all lighting instructions before attempting

to ignite heater.

1.  Turn the heater regulator knob counterclock-

wise to the "HI" position.

2.  Repeatedly push and release the piezo ignitor

(dual burner), or place a lighted match near the

face of the heating element (mesh screen) of the

burner you are lighting, using the hole located

on the side of the reflector. See Figure 6.

3.  Depress the red button on the safety valve

admitting gas to the burner (see Figure 6).