Sanyo RCS-SH80UA.WL User Manual
1
1 - 9
To warm up the system, the power mains must be turned on at least five (5) hours before operation.
STEP 1
To start the air conditioner
Press the operation button (ON/OFF button).
Press the operation button (ON/OFF button).
STEP 2
Setting the mode
Press the MODE button to select the mode of your choice.
Press the MODE button to select the mode of your choice.
[
(AUTO), (HEAT), (DRY), (COOL)
or (FAN)]
STEP 3
Setting the fan speed
Press the FAN SPEED selector button to select the fan speed of your choice.
Press the FAN SPEED selector button to select the fan speed of your choice.
[
(AUTO), (HI.), (MED.)
or (LO.)]
If AUTO is selected, the fan speed switches automatically.
STEP 4
Setting the temperature
Use the
Use the
or
button as appropriate to change the temperature setting as desired.
(
reduces the temperature, and
increases the temperature.)
STEP 5
Setting the airflow direction
When more than one indoor unit is connected, the UNIT button is used first to select a
unit. Then use the FLAP button to set the airflow direction to a specific angle or to
sweep. (Refer to the description of the remote control unit.)
When more than one indoor unit is connected, the UNIT button is used first to select a
unit. Then use the FLAP button to set the airflow direction to a specific angle or to
sweep. (Refer to the description of the remote control unit.)
STEP 6
To stop the air conditioner
Press the operation button (ON/OFF button) again.
Press the operation button (ON/OFF button) again.
Operation
STEP 1, 6
STEP 3
STEP 2
STEP 4
STEP 5
NOTE
NOTE
(AUTO) and
(HEAT) are used only for heat pump type.
06-212 PAC-i_IM_Sec1 4/12/06 7:15 PM Page 9