Desa 000 BTU TB103 User Manual

Page of 56
www.desatech.com
119143-01A
3
7.  Use only in well-vented areas. Before using 
heater,  provide  at  least  a  three-square-
foot opening of fresh, outside air for each 
100,000 Btu/Hr (105,500 k/j) of rating.
8.  Do not use heater outdoors or in occupied 
dwellings.
9.  Do  not  use  heater  in  living  or  sleeping 
quarters.
10. Keep appliance area clear and free from 
combustible  materials,  gasoline,  paint 
thinner and other flammable vapors and 
liquids. Dust is combustible. Do not use 
heater in areas with high dust content.
11. If this heater is equipped with a thermo-
stat. Heater may start at anytime.
1. Check  heater  for  damage  before  each 
use. Do not use a damaged heater.
13. Use only propane/LP gas set up for vapor 
withdrawal.
14. Keep propane tank(s) below 100° F (38° C).
15. Do not use heater in a basement or below 
ground level. Propane/LP gas is heavier 
than air. If a leak occurs, propane/LP gas 
will sink to the lowest possible level.
16. Use only the hose and factory regulator 
provided with the heater.
17. Check hose before each use of heater. If 
highly worn or cut, replace with hose speci-
fied by manufacturer before using heater.
18. Do  not  alter  heater.  Keep  heater  in  its 
original state.
19. Do not use heater if altered.
0. Keep  heater  at  least  6  feet  (1.8  m)  from 
propane/LP tank(s). Do not point heater at 
propane/LP tank(s) within 0 feet (6.1 m).
1. Minimum  heater  clearances  from  com-
bustibles: Outlet: 8 Ft. (.4 m), Sides:  
Ft. (0.6 m), Top: 6 Ft. (1.8 m), Rear:  Ft. 
(0.6 m).
. Locate heater on stable and level surface 
if heater is hot or running.
3. Keep  children  and  animals  away  from 
heater.
4. Turn  off  propane/LP  supply  and  unplug 
heater when not in use.
5. Never block air inlet (rear) or hot air outlet 
(front) of heater.
6. Never  move,  handle  or  service  a  hot, 
operating or plugged in heater.
SAFETy INFORMATION
Continued
7. Never attach duct work to front or rear of 
heater.
8. Use only original replacement parts. This 
heater  must  use  design-specific  parts. 
Do  not  substitute  or  use  generic  parts. 
Improper replacement parts could cause 
serious or fatal injuries.
9. Do not use this product without leg and 
foot assembly.
PRODUCT 
IDENTIFICATION
Figure 1 - 55/85/125,000 Btu/Hr Models
Cord Cleat
Adjustable Foot
Burn Rate 
Adjustment 
Knob 
Handle
Hot Air 
Outlet 
(Front)
Air Inlet 
(Rear)
Figure 2 - 170,000 Btu/Hr Models
Cord Cleat
Adjustable 
Foot
Burn Rate 
Adjustment 
Knob
Handle
Hot Air Outlet 
(Front)
Air Inlet 
(Rear)
Automatic 
Gas Control 
Valve Button
Thermostat 
Knob