GE AJCS 10 AZ User Manual

The air conditioner

Make sure the air conditioner plug is

is unplugged

pushed completely into the outlet.

The fuse is blown/circuit

Check the house fuse/circuit breaker  

breaker is tripped

box and replace fuse or reset the breaker.

Power failure

If power failure occurs, turn the mode

control to 

. When power is restored,

wait 3 minutes to restart the air conditioner

to prevent tripping of the compressor

overload.

There is a protective time delay (up to 3

minutes) in the heat/cool and heat pump

models. Wait 3 minutes for the air

conditioner to resume heating or cooling.

Ice blocks the airflow

Set the mode control at 

or

and stops the air conditioner

with the temperature at a

from cooling the room

warmer setting.

Airflow is restricted

Make sure there are no curtains, blinds

or furniture blocking the front of the 

air conditioner.

The temperature control

Turn the knob to a warmer or cooler setting.

may not be set high

The coolest setting provides maximum

or low enough

cooling. The warmest setting provides

maximum heating on models with heat.

The air filter is dirty

Clean the filter at least every 30 days.

See the Care and Cleaning section.

The room may have been hot

When the air conditioner is first turned on

or cold

you need to allow time for the room to

cool down or warm up.

Cold air is escaping

Check for open furnace floor registers and

cold air returns.

Set the exhaust vent in the closed position.

Cooling coils have iced up

See freezing up below.