Fujitsu 9319356051 User Manual
En-6
PREPARATION
CAUTION
● Take care to prevent infants from acciden-
tally swallowing batteries.
● When not using the Remote Controller for
an extended period, remove the batteries to
avoid possible leakage and damage to the
unit.
avoid possible leakage and damage to the
unit.
● If leaking battery fl uid comes in contact
with your skin, eyes, or mouth, immediately
wash with copious amounts of water, and
consult your physician.
wash with copious amounts of water, and
consult your physician.
● Dead batteries should be removed imme-
diately and disposed of properly, either in a
battery collection receptacle or to the appro-
priate authority.
battery collection receptacle or to the appro-
priate authority.
● Do not attem pt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Also, do not use together with recharge-
able batteries or other types of battery.
Batteries should last about 1 year under
normal use. If the Remote Controller's
operating range becomes appreciably
reduced, replace the batteries and press
the RESET button with the tip of a ball-
point pen or other small object.
batteries of different types.
Also, do not use together with recharge-
able batteries or other types of battery.
Batteries should last about 1 year under
normal use. If the Remote Controller's
operating range becomes appreciably
reduced, replace the batteries and press
the RESET button with the tip of a ball-
point pen or other small object.
Load Batteries (AAA/R03/LR03
× 2)
1
Slide the front cover to take it off.
Slide in the direction of the arrow.
2
Insert
batteries.
Be sure to align the battery polarities (
+ / -
) correctly.
3
Close the front cover.
Set the day of the week and the current time
1
Press the CLOCK ADJUST button
.
2
Press the SELECT button
to select the day of
the week
Press the NEXT button
3
Press the SELECT
buttons
to adjust the clock to
the current time.
button : Press to advance the time.
button : Press to reverse the time.
(Each time the buttons are pressed, the time will be advanced/reversed in
1-minute increments; hold the buttons depressed to change the time quickly
in 10-minute increments.)
1-minute increments; hold the buttons depressed to change the time quickly
in 10-minute increments.)
4
Press the SEND button
.
This completes the time setting and starts the clock.
● Press the SEND button, when you are close to the main unit. If you do so
when far from the main unit, the signal may not get properly sent, and the
settings may not get properly confi gured.
settings may not get properly confi gured.
To Use the Remote Controller
● The Remote Controller must be pointed at signal receiver to operate correctly.
● Operating Range: About 20 ft.
● When a signal is properly received by the indoor unit, a beeping sound will be heard.
● If no beep is heard, press the Remote Controller button again.
● Operating Range: About 20 ft.
● When a signal is properly received by the indoor unit, a beeping sound will be heard.
● If no beep is heard, press the Remote Controller button again.
Remote Controller Holder
Turn on the Power
Turn on the circuit breaker
1 Mount the Holder.
Screws
2 Set the Remote
Controller.
Insert
Press in
3 To remove the Remote Con-
troller (when use at hand).
Slide up
Pull out
RESET
CAUTION
● If there is a curtain or a wall between the
remote control and the receptor, the signal
will not reach it.
will not reach it.
● When the receptor receives strong light, the
air-conditioner may not operate correctly.
Avoid direct exposure to sunlight, and keep
the signal-receiving part away from lights
and fl at panel television screens.
Avoid direct exposure to sunlight, and keep
the signal-receiving part away from lights
and fl at panel television screens.
The signal may not be received in rooms
with instantaneous fl uorescent lights (such
as inverter type ones). In such cases,
please consult at the store where you pur-
chased the product.
as inverter type ones). In such cases,
please consult at the store where you pur-
chased the product.
● Please place the remote control in a place
which will not be affected by heat from di-
rect sunlight and home heaters.
rect sunlight and home heaters.
● Please do not apply strong shocks to the
remote controller or pour water on it.
In the initial state (or, when resetting it),
ENERGY SAVING becomes enables.
(See page 10.)
ENERGY SAVING becomes enables.
(See page 10.)
MO
TU
WE
TH
FR
SA
SU
No good
9319356051_OM.indb 6
9319356051_OM.indb 6
12/5/2011 3:25:32 PM
12/5/2011 3:25:32 PM