GE 3200 User Manual

3-Minute

Dela

y

You may hear a pinging or popping noise caused by water being  
picked up and thrown against the condenser on rainy days or 
when the humidity is high. This design feature helps remove
moisture and improve efficiency.

You may hear relays click when the controls cycle on and off or are
adjusted to change the room temperature.

Water will collect in the base pan during high humidity or on rainy
days. The water may overflow and drip from the outdoor side
of the unit.

The indoor fan runs continuously when the unit is operating in the
cooling mode, unless the fan switch behind the room cabinet is set 
at fan cycle (up). This will cause the fan to cycle on and off with the 
compressor. You may also hear a fan noise stop and start.

You may notice a few minutes delay in starting if you try to restart the
Zoneline too soon after turning it off or if you adjust the thermostat
right after the compressor has shut off. This is due to a built-in
restart protector for the compressor that causes a 3-minute delay.

The compressor shuts off during the defrost cycle. Full resistance
heat comes on during the defrost cycle to maintain room comfort.

To protect the compressor and prevent short cycling, the unit is
designed to run for a minimum of 3 minutes, after the compressor
starts at any thermostat setting.

POP!

“CLICK”

D R I P

COMPRESSOR

PROTECT