York D1EE 060 User Manual

YORK Model DEE units are single package air conditioners

designed for outdoor installation on a rooftop or a slab. Electric

heaters are available as field-installed accessories.

The units are completely assembled on rigid, permanently

attached base rails. All piping, refrigerant charge, and electrical

wiring is factory-installed and tested. The units require only

electric power and duct connections at the point of installation.

The electric heaters have nickel-chrome elements and utilize

single point power connection.

As soon as a unit is received, it should be inspected for possible

damage during transit. If damage is evident, the extent of the

damage should be noted on the carrier's freight bill. A separate

request for inspection by the carrier's agent should be made in

writing. Refer to Form 50.15-NM for additional information.

Additional information on the design, installation, operation and

service of this equipment is available in the following reference

forms:

•

55.70-N1

-General Installation

•

55.70-N2

-Pre-start & Post-start Check List

•

530.18-N1.2V -Economizer Accessory

•

530.18-N1.13V -Man. Outdoor Air Damper Accy 0-35%

•

530.18-N1.14V -Man. Outdoor Air Damper Accy 0-100%

•

530.18-N1.12V -Motorized Outdoor Air Damper Accy.

•

530.18-N1.8V -Coil Guard

•

530.18-N7.1V -Electric Heater Accessory

•

530.18-N7.2V -Fuse Block Accessory

•

690.15-N25V

-Low Ambient to 0°F

Renewal Parts:

•

Refer to Parts Manual for complete listing of replacement

parts on this equipment.

All forms referenced in this instruction may be ordered from:

Design certified by U.L. and C.G.A. as follows:

1. For use as a cooling only unit or cooling unit with electric heat.

2. For outdoor installation only.

3. For installation on combustible material.

® 

SUNLINE 2000™

Supersedes: 035-12046-002-A-0302

035-12046-003-A-0204

Installer should pay particular attention to the words: NOTE, CAUTION and WARNING. Notes are intended to clarify or

make the installation easier. Cautions are given to prevent equipment damage. Warnings are given to alert installer that per-

sonal injury and/or equipment damage may result if installation procedure is not handled properly.

THE ENCLOSED INSTALLATION INSTRUCTIONS AND ANY APPLICABLE

LOCAL, STATE, AND NATIONAL CODES INCLUDING, BUT NOT LIMITED

TO, BUILDING, ELECTRICAL, AND MECHANICAL CODES.

THIS PRO DUCT M UST BE INSTALLED IN STRICT COMPLIANCE W ITH

OPERATION OF THE  PRODUCT COULD CAUSE  PERSONAL  INJURY

O R   P R O P E R T Y   D A M A G E .

INCORRECT INSTALLATION MAY CREATE A CONDITION W HERE THE