Heatiator BCDV36 User Manual

01-03

33606 Rev D

BUILDER'S CHOICE SERIES INSTALLATION INSTRUCTIONS

D. FRAMING

Figure 3 shows a typical framing of this appliance using

combustible materials. Figure 4 shows the mantel heights

for mantel projections. All required clearances to

combustibles must be adhered to.

CAUTION:

Wear gloves and safety glasses for protection.

Figure 3 - Framing

Figure 4 - Mantel Height

CAUTION:

Provide adequate clearances around the air open-

ings into the combustion chamber and adequate ac-

cessibility clearances for servicing and proper op-

eration.

E. SETTING THE APPLIANCE

This appliance may be placed on a smooth combustible or noncombustible continuous, flat surface. When the appliance

is installed directly on carpeting, tile or other combustible material other than wood flooring, the appliance shall be

installed on a metal or wood panel extending the full width and depth of the appliance. Slide the appliance into position

and level the appliance from side-to-side and front-to-back. Shim as necessary.
Secure the appliance by bending out the nailing flanges on each side of the appliance and nail to framing. The nailing

flanges have been positioned 5/8 inch back from the front of the appliance to allow the addition of drywall.

* from base of appliance

WARNING!

To prevent contact with sagging or loose insulation, the appliance must not be installed against vapor barriers or

exposed insulation. Localized overheating could occur and a fire could result.