New Buck Corporation 21 User Manual

Page of 42
SECTION III 
PRE-FAB INSERT INSTALLATION 
 
The Model 21 has been tested with the following: 
 
Heatilator          Security 
Tempco             Preway 
Marco               
 
FMI 
Woodside          Majestic 
 
NOTE:  The  Model  21  may be installed in any of the pre-fabricated frieplaces listed above if  
             they are big enough to accept the heater.   
 
 
NOTE: A FULL CHIMNEY LINER IS REQUIRED IN A ZERO CLEARANCE OR  
              PRE -FABRICATED FIREPLACE. 
 
 
NOTE:  The ash lip, smoke baffle, and smoke shelf may be  removed if necessary to provide 
room for these models.  Any  other  alteration to the unit will void ALL NEW BUCK 
CORPORATION. manufacturer's responsibility and liability. 
The warning label below 
must be attached to the pre- fabricated fireplace be for unit is installed. 
 
Except  for the 
“NOTES” 
above, please follow the  instructions  for Masonry Insert 
Installation including Minimum Clearances for stove and floor protector in  Section II. 
 
NOTE:  When installing trim panels “DO NOT COVER ANY EXITING LOVERS OR 
               AIR OPENING IN PRE-FABRICATED FIREPLACE .”  
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
WARNING:  
This fireplace must be 
restored to its original condition for safe use, if 
the fireplace insert is removed. 
11