Leviton ACENTI Leaflet

 To be installed and/or used in accordance with

appropriate electrical codes and regulations.

 If you are unsure about any part of these

instructions, consult a qualified electrician.

 Refer to the individual Acenti™ device's instruction

sheet for complete wiring details.

 For the purposes of illustration, this instruction sheet

will show the mounting of the Acenti Wallplate System using
the Acenti Switch. The mounting of the Acenti Wallplate System
will be the same for all Acenti devices.

 TO AVOID FIRE, SHOCK, OR DEATH; TURN

OFF POWER at circuit breaker or fuse and test that power is off!

• The installation of your Acenti device should now be

at the point where all your electrical connections are
complete and secure.

In order to relieve stress on device when mounting,
dress wall box wires with a bend (refer to
Figure).

Remove mounting screw or electrical tape that is
temporarily holding the Alignment Plate.

In order to relieve stress on device when mounting,
dress wall box wires with a bend (refer to Figure).

• Carefully pass the wired Acenti device through the

Alignment Plate ensuring the tab is towards the
bottom.

• Ensure that cut-outs in alignment plate are

positioned such that the device mounting holes in
the wall box are accessible and tab is on bottom.

• Begin to partially screw in device mounting screws

into wall box mounting holes.

• Align the three tabs in the multi-function clips with

the alignment pins on the Alignment Plate and press
into place.

• Continue mounting of device and Alignment Plate

by tightening the mounting screws until the strap sits
flush and just snug on Alignment Plate.

• Reposition Alignment Plate for leveling if necessary.

Complete installation by lightly tightening mounting
screws until Alignment Plate sits flat on wall surface.

PK-93603-10-03-0B

U.S. & Foreign Patents Pending

Copyright

©

 2004 Leviton Manufacturing Co., Inc.

All Rights Including Trade Dress Rights Reserved

 DO NOT over-tighten device mounting screws.

Over-tightening will cause improper mounting and alignment.
Using a high-torque power screwdriver is not recommended.
Alignment Plate must sit completely flush on wall surface.

For multi-gang installations, the alignment of the devices
installed is important. If necessary, adjust the space between
the paddles/faces to maintain a consistent gap of approximately
1/64" (0.4 mm). This can be done by gently tapping the strap of
the devices in the direction needed with a small screwdriver as
shown.

Mounting: With
"LEVITON" facing up
and notch facing down,
press Acenti™ wallplate
onto device until it
clicks flush to wall
surface.

Place a small
screwdriver in notch on
bottom of wallplate and
gently lift up to remove.

Restore power at circuit breaker or fuse. Installation is
complete.