Runco LS-7 User Manual
Runco LS-7 Installation/Operation Manual
35
PRE
L
IMINAR
Y
The LS-7 Main Menu, shown in Figure 4-2, provides access to the most commonly-used
projector functions.
projector functions.
Figure 4-2. LS-7 Main Menu
1. For best results, Runco recommends that you set
ConstantContrast to Off before adjusting Brightness, Contrast and
other image quality settings in this menu (refer to
ConstantContrast on page 48). After you have completed the
initial calibration, set ConstantContrast to On if desired.
other image quality settings in this menu (refer to
ConstantContrast on page 48). After you have completed the
initial calibration, set ConstantContrast to On if desired.
2. Image controls only operate on the active source. To adjust the PIP
source, switch to the PIP source (thereby making it the active
source), adjust the controls and then switch back.
source), adjust the controls and then switch back.
Note