Runco LS-10D User Manual
8
Runco LS-10d Installation/Operation Manual
PRE
L
IMINAR
Y
2.2
LS-10d Rear Panel
LS-10d Rear Panel
Figure 2-5 shows the LS-10d rear panel.
Figure 2-3. LS-10d Rear Panel
1.
DHD INPUT
An HDCP-compliant digital video input for connecting the HDMI output from the DHD
Controller.
An HDCP-compliant digital video input for connecting the HDMI output from the DHD
Controller.
2.
TRIGGER 1
Provides 12 (+/- 1.5) volt switched output for an anamorphic lens transport (if
installed) with 250mA current capacity and short protection.
Provides 12 (+/- 1.5) volt switched output for an anamorphic lens transport (if
installed) with 250mA current capacity and short protection.
3.
POWER INPUT (100 to 240 VAC)
Connect the LS-10d to power here.
Connect the LS-10d to power here.
1
2
3
You can also use a 12-volt trigger output on the DHD Controller to
control the anamorphic lens transport.
control the anamorphic lens transport.
The other connectors are not used. Connect all signal sources and
other equipment to the DHD Controller.
other equipment to the DHD Controller.
Note
Note