Runco LS-10D User Manual

To install batteries in the remote control: 

1.

Press down the tab on the cover and 
pull the cover in the direction of the 
arrow.

2.

Insert the included batteries. Ensure 
that the polarities correctly match the 

 and 

 markings inside the battery 

compartment.

3.

Insert the lower tab of the cover into 
the opening, and press down the cover 
until it clicks in place.

• Make sure that the battery polarities are correct when installing the batteries.

• Do not mix an old battery with a new one or different types of batteries.

• If you will not use the remote control for a long time, remove the batteries to avoid 

damage from battery leakage.

• Make sure that there is nothing obstructing the infrared beam between the remote 

control and the IR receiver on the DHD Controller.

• If the effective range of the remote control decreases, or it stops working, replace the 

batteries with new ones.

• The remote control may fail to operate if the infrared remote sensor is exposed to bright 

sunlight or fluorescent lighting.

• Ambient conditions may possibly impede the operation of the remote control. If this 

happens, point the remote control at the DHD Controller, and repeat the operation.