Runco X-200i User Manual

To install batteries in the remote control:

1.

Slide the battery compartment cover in the direction of the arrow to remove it.

2.

Install two AA batteries with the correct polarity.

3.

Replace the cover. 

• Make sure that the battery polarities are correct when installing the batteries.

• Do not mix an old battery with a new one or different types of batteries.

• If you will not use the remote control for a long time, remove the batteries to avoid 

damage from battery leakage.

• Do not expose batteries to excessive heat such as from sunshine, fire or the like. 

• In most situations, you can simply point the remote control at the screen which will 

reflect the IR signal from the remote back toward the IR receiver on the projector. In 
some cases, however, ambient conditions may prevent this. If so, point the remote 
control at the projector and try again.

• If the effective range of the remote control decreases, or it stops working, replace the 

batteries with new ones.

• The remote control may fail to operate if the infrared remote sensor is exposed to bright 

sunlight or fluorescent lighting.

• During 3D operation, the remote control response may be adversely affected by 

interference from the Active 3D Emitter. It may help to point the remote directly at the 
projector during 3D operation. In some cases, it may be better to use the projector 
keypad when viewing 3D content.

1.

2.

3.