Sony HT-SS100 User Manual
58
GB
No sound is output from the receiver
and TV speaker while using the System
Audio Control function.
and TV speaker while using the System
Audio Control function.
• Make sure the TV is compatible with the
System Audio Control function.
• If you cannot listen to the sound of a
component connected to the receiver
– Select the appropriate input when you
– Select the appropriate input when you
want to watch a program on a
component connected via HDMI
connection to the receiver.
component connected via HDMI
connection to the receiver.
– Change the TV channel when you want
to watch a TV broadcast.
– Select the component or input you want
to watch when you watch a program on
the component connected to the TV.
Refer to the operating instructions of the
TV on this operation.
the component connected to the TV.
Refer to the operating instructions of the
TV on this operation.
When the receiver is in standby mode,
there is no image or sound on the TV.
there is no image or sound on the TV.
• When the receiver is in standby mode,
image and sound are output from the
HDMI component selected the last time
you turned off the receiver. If you are
enjoying other component, play the
component and perform the One-Touch
Play operation, or turn on the receiver to
select the HDMI component you want to
enjoy.
HDMI component selected the last time
you turned off the receiver. If you are
enjoying other component, play the
component and perform the One-Touch
Play operation, or turn on the receiver to
select the HDMI component you want to
enjoy.
• Make sure “P.SAVE” is set to “SAVE
OFF” in the SET HDMI menu if you
connect components not compatible with
the “BRAVIA” Sync to the receiver (page
48).
connect components not compatible with
the “BRAVIA” Sync to the receiver (page
48).
The volume turns down when the
output method changes from the TV
speaker to the speakers connected to
the receiver.
output method changes from the TV
speaker to the speakers connected to
the receiver.
• The Volume Limit function is working.
For details, see “Using the Volume Limit
function” (page 47).
function” (page 47).
Tuner
The FM reception is poor.
• Use a 75-ohm coaxial cable (not supplied)
to connect the receiver to an outdoor FM
antenna as shown below. If you connect
the receiver to an outdoor antenna, ground
it against lightning. To prevent a gas
explosion, do not connect the ground wire
to a gas pipe.
antenna as shown below. If you connect
the receiver to an outdoor antenna, ground
it against lightning. To prevent a gas
explosion, do not connect the ground wire
to a gas pipe.
Radio stations cannot be tuned in.
• Check that the antennas are connected
securely. Adjust the antennas and connect
an external antenna, if necessary.
an external antenna, if necessary.
• The signal strength of the stations is too
• No stations have been preset or the preset
stations have been cleared (when tuning
by scanning preset stations). Preset the
stations (page 41).
by scanning preset stations). Preset the
stations (page 41).
RDS does not work.
a)
• Make sure that you are tuned to an FM
RDS station.
• Select a stronger FM station.
The RDS information that you want
does not appear.
does not appear.
a)
• Contact the radio station and find out
whether they actually provide the service
in question. If so, the service may be
temporarily out of order.
in question. If so, the service may be
temporarily out of order.
a)
Models of area code CEL, CEK only.
AM
ANTENNA
Receiver
To ground
Ground wire
(not supplied)
(not supplied)
Outdoor FM antenna