Sony HT-SS1200 User Manual

D:\Chin Meng's job\SONY-HA\HT-SF1200_R2\1200_data\3210767121\GB03CON_HT-SF1200-
CEL.fm

[HT-SF1200/HT-SS1200]

3-210-767-12

(2)

V/v repeatedly to select 

Select “SAVE” in step 2.
The measurement results are saved.

Try the remedies and perform the Auto 
Calibration again.

Record down the error code.

Press  , “RETRY Y” appears on the 
display.

Rectify the error. 
For details, see “When error codes appear” 
above.

Press   to perform Auto Calibration again.

If a warning on the measurement result is 
present, detailed information is displayed.

 to return to step 2 of 

RETRY

Performs the Auto 

Calibration again.

SAVE 

Saves the measurement 

results and exits the setting 

process.

WARN CHK

Displays warning 

concerning the 

measurement results. See 

PHASE

Displays the phase of each 

speaker (in phase/out of 

phase). See “When you 

select “PHASE”” (page 27).

DISTANCE

Displays the measurement 

result for speaker distance.

LEVEL

Displays the measurement 

result for speaker level.

EXIT

Exits the setting process 

without saving the 

measurement results.

ERROR 32

None of the speakers were 

detected. Make sure that the 

optimizer microphone is 

connected properly and perform 

the Auto Calibration again.

If the optimizer microphone is 

connected properly but the error 

code appears, the optimizer 

microphone cable may be 

damaged or improperly connected.

ERROR F 33

• None of the front speakers are 

connected or only one front 
speaker is connected.

• The optimizer microphone is not 

connected.

ERROR SR 33 Either the left or right surround 

speakers is not connected.

ERROR SW 33 Sub woofer is not connected. 

Connect the sub woofer to the 

SUBWOOFER terminal.

ERROR 33

Wrong speaker detection due to 

noise. Make sure the environment 

is quiet during Auto Calibration.

WARN 40

The Auto Calibration has 

completed. However, the noise 

level is high. You may be able to 

perform the Auto Calibration 

properly if you try it again, even 

though the measurement cannot 

be performed in all environments. 

Try to perform the Auto 

Calibration in a quiet 

environment.

WARN 41

The sound input from the 

optimizer microphone is out of 

the acceptable range. It is louder 

than the loudest sound that can be 

measured. Try to perform the 

Auto Calibration when the 

environment is quiet enough to 

allow proper measurement.