Sony HM-982RW User Manual
Playback of TAPE
29
Knowledge section
Preparation section
Application section
Basic section
To wind tape at high speed
To stop playback
Ejecting the cassette tape
To reduce tape noise (DOLBY NR)
“
NR” lit ................... Dolby NR is used.
“
NR” goes off ......... Dolby NR is deactivated.
Each press switch the modes as follows.
The Dolby Noise Reduction system reduces inherent
noise to tape playback.
Set the Dolby NR according to the Dolby NR used
when recording each cassette tape.
noise to tape playback.
Set the Dolby NR according to the Dolby NR used
when recording each cassette tape.
Selection of reverse mode (TAPE RVS.)
1 Press the MENU key.
3 Select.
4 Set it.
1 REVERSE (
)
Both sides are played back (recorded), and then
the tape stops.
the tape stops.
2 ENDLESS (
)
Both sides are played back endlessly.
(The tape stops after recording onto both sides.)
(The tape stops after recording onto both sides.)
3 ONE WAY (
)
Only one side is played back (recorded), and
then the tape stops.
then the tape stops.
(The initial setting is "REVERSE".)
A tip for use of the tape counter
The tape counter is set to “0000” when a cassette tape is
loaded. By writing down the counter reading in case you
want to interrupt recording (playback) in the middle of
the tape, the memo will be helpful as a reference for lo-
cating the same position when continuing the recording
(playback) the next time. The tape counter figure decre-
ments during recording or playback of the back side (while
the
loaded. By writing down the counter reading in case you
want to interrupt recording (playback) in the middle of
the tape, the memo will be helpful as a reference for lo-
cating the same position when continuing the recording
(playback) the next time. The tape counter figure decre-
ments during recording or playback of the back side (while
the
2 tape transport indicator is lit).
To reset the tape counter to "0000", eject the cassette
tape temporarily. This will reset the counter.
tape temporarily. This will reset the counter.
Remote control unit only
2 Select “TAPE RVS. ?”.
22
33
TUNING
DOLBY NR
STOP
7
#
#
MULTI
CONTROL
SET
0
TAPE IN
When you are operating the remote, press the
REV.MODE key to change the reverse mode.
REV.MODE key to change the reverse mode.
÷ If you are operating the main unit, press the 4, ¢ key.
÷ Press the 7 STOP key to stop fast winding.
÷ The same function is also available using the 4, ¢ key
on the remote control unit.
Transport direction indicators
Fast
reverse
reverse
Fast
forward
forward
Indicator Tape transport direction
Direction of insertion
into main unit
into main unit
\
1
(
4)
¡
(
¢)
¡
(
¢)
1
(
4)
3
2
Direction of insertion
into main unit
into main unit
\
Notes
Notes
÷When playback with the tape reverse mode of "
"
(REVERSE) is started in tape transport direction "
2",
playback ends after having played only the side where it
was started.
was started.
÷When recording with the tape reverse mode of "
"
(REVERSE) is started in tape transport direction "
2",
recording ends after having recorded only the side where
it was started.
it was started.
÷When recording with the tape reverse mode of "
"
(ENDLESS) is started in tape transport direction "
2",
recording ends after having recorded only the side where
it was started.
it was started.