Sony HM-982RW User Manual
65
Knowledge section
Preparation section
Application section
Basic section
Convenient recording of CD player output
Program the desired sequence of CD tracks.
Check the current play mode of the CD player.
1
3
1 Perform steps 1~3 of the procedure in ”Recording
on TAPE”.
‚
2 Select the “CD” input.
¢
3 Load the recording source disc in the CD player.
¢
Make the preparations for recording.
Be sure to put the cassette deck in stop mode.
Desired CD tracks can be programmed in the desired sequence and recorded onto a tape.
Program recording
(PGM mode + O.T.E.)
2
÷ Recording begins from the first track in the program and
completes when the entire program has been recorded.
÷ When either the playback or recording operation stops, the
other operation also stops.
÷ When you are operating the main unit, select “O.T.E. Mode”
in the menu mode then select “CD
=
=
=
=
=TAPE“ and press the
SET key to start recording.
÷ When recording completes, the tape stops after leaving a no-
sound blank of about 4 seconds.
Start recording.
4
Perform steps
2 and 3 of the procedure in ”Lis-
tening in the desired sequence (Program play-
back)”.
back)”.
u
CD
TAPE
=
To interrupt a recording
STOP
7
CD
=TAPE
This system can record signals on Normal (TYPE ) and
High (TYPE ) position tapes. Remember that the Metal
(TYPE
High (TYPE ) position tapes. Remember that the Metal
(TYPE
) tapes cannot be used with this system.
Do not use a cassette tape with more than 90-minute recording time, for the tape used with such a cassette is very
thin and tends to cause troubles such as entanglement around the pinch roller or cutting of tape.
thin and tends to cause troubles such as entanglement around the pinch roller or cutting of tape.
Press the
7 (stop) key on the main unit or 7 STOP
key on the remote. (This stops both recording and
playback.)
playback.)
If it is in play mode, stop it.