Manualsbrain.com
  1. Manuals
  2. Brands
  3. EIKI
  4. EIP-D450
  5. User Manual

EIKI EIP-D450 User Manual

Download
Page of 66
57
4
  Remove the lamp unit. 
Loosen the securing screws from the lamp 
unit. Hold the lamp unit and pull it in the 
direction of the arrow. At this time, keep 
the lamp unit horizontal and do not tilt it.
5
  Insert the new lamp unit.
Press the lamp unit fi rmly into the lamp unit 
compartment. Fasten the securing screws.
6
  Replace the lamp unit cover.
Align the tab on the lamp unit cover 
(1) and place it while pressing the cover 
(2) to close it. Then tighten the user 
service screw (3) to secure the lamp unit 
cover.
Info
If the lamp unit and lamp unit cover 
are not correctly installed, the power 
will not turn on, even if the power 
cord is connected to the projector.
•
Resetting the Lamp Timer
Reset the lamp timer after replacing the lamp. 
Info
Make sure to reset the lamp timer only when 
replacing the lamp. If you reset the lamp timer 
and continue to use the same lamp, this may 
cause the lamp to become damaged or 
explode.
•
1
  Connect the power cord and 
open the lens shutter fully.
Plug the power cord into the AC socket of 
the projector.
2
  Reset the lamp timer.
While simultaneously holding down 
MENU/HELP, ENTER and R on the 
projector, press STANDBY/ON on the 
projector.
“LAMP 0000H” is displayed, indicating 
that the lamp timer is reset.
•
•
•
•
•
•
4
Securing screws
Securing screws
5
6
AC socket
AC socket
1
ENTER button
MENU/HELP 
button
R button
STANDBY/ON 
button
ENTER button
MENU/HELP 
button
R button
STANDBY/ON 
button
2