Emerson Series 3000 MVD User Manual

112

To set the security switch on a Model 3300 or Model 3500 mounted in a rack:

1. Loosen the captive screws that secure the front panel of the Series 3000 device to the rack.

2. Slide the platform out of the rack.

3. Remove the protective mask (see Figure 14-4).

4. The security switch is located on the back panel of the platform. To secure the device, set the 

switch so the toggle is downward. See Figure 14-4.

5. Reinstall the protective mask.

6. Install a weights and measures seal (see Section 14.7) through the custody transfer tab shown 

in Figure 14-4. This installation must be performed by a weights and measures inspector.

7. Align the platform with the guide rails in the rack.

8. Slide the platform into the rack. Make sure the pins on the back panel make contact with the 

wiring connectors.

9. (Optional) Replace the top two or bottom two screws in the front panel of the platform with the 

supplied lockout screws. See Figure 14-5.

10. Make sure all four front-panel screws are tightly secured to the guide rails in the rack.

11. (Optional) Install a weights and measures seal through the holes in the front panel. See 

Security switch
Security is enabled when toggle is downward

Seal wire will be installed by weights and

measures inspector (see Section 14.7)