Emerson Series 3000 MVD User Manual
Configuration and Use Manual
133
Co
nfi
guri
nfi
guri
ng Custod
y
T
ran
sf
sf
er
Star
tup
Con
fig
urin
g Tic
kets
Con
fig
ur
in
in
g Di
gi
tal
Co
mm
Co
mm
u
n
ic
a
tio
ns
Chapter 16
Startup Procedures
16.1
About this chapter
This chapter explains the procedures that are required for initial startup of the Series 3000 device.
After initial startup, these procedures may be performed as required for troubleshooting or
maintenance.
After initial startup, these procedures may be performed as required for troubleshooting or
maintenance.
The following procedures are discussed:
•
Applying power to the flowmeter
•
Sensor zero
•
Testing the inputs and outputs
•
Milliamp output trim
Note: If you are using a Model 3300 or Model 3350 controller, the sensor zero procedure is not
applicable to your device. Perform the other procedures as applicable.
applicable to your device. Perform the other procedures as applicable.
16.2
Applying power
Before you apply power to the Series 3000 device, close and tighten all housing covers.
Turn on the electrical power at the power supply. The flowmeter automatically tests its display.
During display testing, the screen darkens for approximately five seconds. After the display test is
completed:
During display testing, the screen darkens for approximately five seconds. After the display test is
completed:
1. The Micro Motion logo is displayed for two to three seconds.
2. An application list is displayed for two to three seconds.
3. The device enters operation mode:
•
If the discrete batch application is not installed, the process monitor screen is displayed, as
shown in Figure 17-1.
shown in Figure 17-1.
•
If the discrete batch application is installed, the batch process screen is displayed (see
Figure 18-1).
Figure 18-1).
WARNING
Operating the Series 3000 device without covers in place creates electrical
hazards that can cause death, injury, or property damage.
hazards that can cause death, injury, or property damage.
Make sure safety barrier partition and covers for the field-wiring, circuit board
compartments, electronics module, and housing are all in place before applying
power to the Series 3000 device.
compartments, electronics module, and housing are all in place before applying
power to the Series 3000 device.